When the hole punch dust bin becomes full, the MFP will continue to print but will not hole punch until the dust bin is emptied. Follow the instructions below to empty it.
TOSHIBA e-STUDIO7516AC
1. Open the Hole Punch Unit cover.
2. Pull out the hole punch dust bin.
3. Dispose of the paper punching.
4. Push back in the hole punch dust bin.
5. Close the Hole Punch Unit cover.
TOSHIBA e-STUDIO5015AC
1. Lift up the control panel and then open the front cover of the finisher.
2. While holding the green lever, move the finisher to the left until it stops
3. Open the Hole Punch Unit while pushing the green lever.
4. After moving the hole punch dust bin to the left, pull it toward you.
5. Dispose of the paper punchings.
6. Push back in the hole punch dust bin.
7. Return the Hole Punch Unit to its original position.
8. Carefully return the finisher to its original position.
CAUTION
Do not put your hand or fingers on the top of the finisher when closing it. They could be caught, and cause injury.
9. Close the front cover of the finisher.
If you experience any issues, please contact the Help Desk at helpdesk@susqu.edu or 570-372-4502